Split U-shaped cable grommets
Split U-shaped cable grommet
- The UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables
- The wall thickness of the enclosure can be from 1 to 4 mm.
- After fitting the grommet with the cable, it is inserted into the recommended cut-out
- The enclosure cover is then placed on the lower part.
- By screwing the cover tightly on the enclosure, pressure acts on the cable grommet
- enables a sealing rate of up to IP54.
-
56100 | UTB bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables
-
56101 | UT 4-6 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 4 - 6 mm
-
56102 | UT 5-7 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 5 - 7 mm
-
56103 | UT 6-8 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 6 - 8 mm
-
56104 | UT 7-9 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 7 - 9 mm
-
56105 | UT 8-10 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 8 - 10 mm
-
56106 | UT 9-11 bk| Split U GrommetsThe UT cable grommet is an U-shaped cable bushing and makes it possible to route single pre-connectorised cables, Clamping range 1 x 9 - 11 mm